💒Solar Lamp Circuit Board Control💒
2 Đánh Giá
Đã Bán 7
63
44.100 đ
Xem sản phẩm trên Shopee
Cài đặt Bigbuy360 ExtensionQuốc tế
thứ ba 16/11/2021 lúc 02:22 CH
MÔ TẢ SẢN PHẨM
Specifications:
Material: ABS
Size: 74*26*10mm/2.91*1.02*0.39"
Purpose:Controller for Solar Wall Lamp.
Light mode:
Automatically turn off the light during the day and turn on the light by human body induction at night.
Induction mode: microwave radar induction
Induction Distance: 6-10m
Induction time: 15 seconds high brightness, normally-on at weak light
Battery input: 3.2V/3.7V
Output power: <10W
Note:
There is no overcharge and overdischarge protection.
Batteries should be connected with their own protective plates.
Notes for testing:
1. When testing the induction mode, there is no movement of objects within 12 meters, including the movement of hands and feet. Otherwise, it will be tested.
2. When multiple induction modules are together, they may interfere with each other, resulting in insensitive induction or false triggering.
3. The surface of the patch part is the launching surface. It can't stick adhesive and glue. It can't be covered by metal.
4. The distance between the positive side and the negative side of the inductor should not be less than 2cm from the metal.
5. Induction signals can penetrate glass, plastics, walls, etc.
Notes:
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow 1-3cm measuring deviation due to manual measurement.
Included:
1 XCircuit Board
Material: ABS
Size: 74*26*10mm/2.91*1.02*0.39"
Purpose:Controller for Solar Wall Lamp.
Light mode:
Automatically turn off the light during the day and turn on the light by human body induction at night.
Induction mode: microwave radar induction
Induction Distance: 6-10m
Induction time: 15 seconds high brightness, normally-on at weak light
Battery input: 3.2V/3.7V
Output power: <10W
Note:
There is no overcharge and overdischarge protection.
Batteries should be connected with their own protective plates.
Notes for testing:
1. When testing the induction mode, there is no movement of objects within 12 meters, including the movement of hands and feet. Otherwise, it will be tested.
2. When multiple induction modules are together, they may interfere with each other, resulting in insensitive induction or false triggering.
3. The surface of the patch part is the launching surface. It can't stick adhesive and glue. It can't be covered by metal.
4. The distance between the positive side and the negative side of the inductor should not be less than 2cm from the metal.
5. Induction signals can penetrate glass, plastics, walls, etc.
Notes:
1. Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
2. Please allow 1-3cm measuring deviation due to manual measurement.
Included:
1 XCircuit Board
